RubyRain
Well-known Member
Cavy Slave
- Joined
- Feb 9, 2011
- Messages
- 1,188
This cage was inspired by @lissie and @Inle_Rabbit . 
I could not go as big as theirs and my hubby wanted an easy project so this is the result.
The cage is 28x60 with 10 inch sides. So the same as a 2x4 c&c which was as big as I could go with my space.
It required just 2 pieces of plywood cut strategically to maximize use. They were cut for free using my diagram at the store so that made it easier too. They cut the plexiglass for free too.
the plexiglass was most expensive component and I did not use the thick stuff that I really wanted.
Total cost=$100
I could not go as big as theirs and my hubby wanted an easy project so this is the result.The cage is 28x60 with 10 inch sides. So the same as a 2x4 c&c which was as big as I could go with my space.
It required just 2 pieces of plywood cut strategically to maximize use. They were cut for free using my diagram at the store so that made it easier too. They cut the plexiglass for free too.
the plexiglass was most expensive component and I did not use the thick stuff that I really wanted.
Total cost=$100
Last edited:
