Tab Content
No Recent Activity

4 Visitor Messages

  1. View Conversation
    Hi I was reading your post about your new pigs and realized I'm adopting my new little boy from the same place I just wanted to ask if they were okay with you living farther away from OC because I live about 3 hours away and I am hoping that I will still get approved. Thanks!
  2. View Conversation
    hey (: how r u?
  3. View Conversation
    Oops! Sorry I wasn't on chat... I had to leave for a second.
  4. View Conversation
    where did you buy your zorb from?
Showing Visitor Messages 1 to 4 of 4

Statistics


Total Posts
Total Posts
256
Posts Per Day
0.07
Last Post
no need to clean anal sac? 01-23-11 05:30 pm
Personal Albums
Total Personal Albums
2
Total Photos
13
Visitor Messages
Total Messages
4
Most Recent Message
11-11-10 12:38 pm
Total Thanks given
Total Thanks given
22
  • Thanks
    23 Rec'd/15 Posts
General Information
Last Activity
04-27-13 04:39 pm
Joined
07-02-10

Gallery Statistics

Statistics

Number of Photos
19
Number of Comments
20
Number of times photos viewed
39,438
Disk space used
1.2MB
Last Photo Uploaded
DSCN5462.JPG
discoloration-on-fur
Last Comment Posted
switch-back-ramp-233-built-in-hidey-view
It is pretty easy, but there are a few tricks.

First you need to find the spot on the outside of the grid that has been welded together. Do NOT try to bend it along that side or the weld will break and then it leaves a sharp edge. So when you find that side then you need to have that side pointed towards you when you bend it.

Now lay the grid down on the floor (carpeted flooring is best) and place your feet along the edge that has the weld (remember that side is facing you). Where your shoes end is pretty much where it will bend so keep this in mind and decide if you want it to have one bend along the middle to make an A frame or two to make a square tunnel.

Then grab the opposite side with both hands and pull it towards you. The weight of your body will be enough to allow it to bend easily.

No results to display...
No results to display...
No results to display...